Creating a SSP585 payu configuration for ESM1.5

Hi All,

Apologies, its unclear if I should continue this thread or start another, but I am in need of a little guidance to try and extend my flux corrected ESM1.5 historical runs following the SSP585 scenario. A scenario is not something that is currently set up in payu, so my question is, can I achieve this simply by extending from my historical runs, and updating the forcing fields to SSP585 (unclear exactly how many forcing files I will need to update)? If so, can someone provide a pointer to where to identify the various forcing fields?

Regards, Shayne

@ShayneM A good reason to start a new topic is that then your question is more likely to be seen and identified as a help request.

So I moved your post to this new topic. Feel free to update the title if I got it wrong. And I’ll get you someone who can help.

Hi @ShayneM, that’s correct that to update from a historical to SSP585 configuration, you’ll need to swap the forcing files in the configuration. I can give some guidance on how to do this in the configuration, but we might need some additional help for locating the SSP585 forcing files on Gadi.

Aerosols, ozone, nitrogen deposition
In the config.yaml file, the following four lines point to the time varying aerosol forcing files. These will need to be replaced with the files for SSP585

The filepaths for the ozone:

and nitrogen deposition:

will also need to be updated with the SSP585 files.

The filepaths in the config.yaml file tell payu where to collect the input files from. The following lines in the atmosphere/um_env.yaml file then tell the UM model which file contains which forcing, and so you’ll need to update the filenames in the section below to match the new files:

Volcanic, and solar forcings
The following two lines point to the volcanic and solar forcings respectively. These will need to be swapped to the SSP585 files:

The filenames in atmosphere/namelists will also need to be updated to match the new files:

Land use change
The following line points to the land use change input file, and it can be swapped with the SSP585 file:

The configuration contains a script which inserts the vegetation fractions from this file into the restart at the end of each year. To get this script working with the new land use file, update the filename in the following line of scripts/update_landuse_driver.sh with the new filename:

Greenhouse gas concentrations
The &clmchfcg section of the atmosphere/namelists file specifies the yearly concentrations for time varying greenhouse gasses.

In the namelist, each greenhouse gas is given and index (1=CO2, 2=CH4, 3=N2O,…), and the following information is specified for each greenhouse gas:

  • clim_fcg_nyears specifies the total number of years of data provided for each greenhouse gas.
  • Each entry for clim_fcg_years specifies which years concentrations are provided for, for a given greenhouse gas
  • Each entry for clim_fcg_levls specifies the yearly mass mixing ratios for a given greenhouse gas
  • Each entry for clim_fcg_rates should be set to -32768.0 – this is required to get the model to use the specified mass mixing ratios directly.

It will be easiest to update this section by copy and pasting it from the namelist used in the CMIP6 SSP585 experiment.

Location of the data on Gadi
Because a payu configuration for SSP585 hasn’t been set up before, I’m not sure where the forcing files and GHG values from the CMIP6 experiment can be found. @tiloz – do you know where @ShayneM would be able to find these files.